GEPRC TAKER F405 BLS 65A V2 STACK

GEPRC TAKER F405 BLS 65A V2 STACK is a powerful FPV drone controller and 4-in-1 ESC kit that combines an STM32F405 processor, an ICM42688-P gyroscope, and a 65 A ESC. Built-in LC filter, dual BEC, 16 MB Blackbox memory, and direct DJI Air Unit connection ensure stable operation and convenient installation, while the ESC supports 3-8S LiPo batteries and DShot150/300/600 protocols.

Features:

• The popular STM32F405 processor is used;
• Integrated latest ICM42688-P gyroscope;
• 16 MB Blackbox memory for flight data;
• Integrated LC filter to reduce power supply interference;
• Updated USB Type-C connector;
• Ability to directly connect DJI Air Unit;
• Comes with TAKER H65 8S BLS 65A 4-in-1 ESC, ensuring smooth and stable control;
• Simple and practical mounting system with vibration dampers to help ensure stable gyroscope operation;
• Two independent BEC power outputs: 12 V / 2.5 A and 5 V / 3 A.

Specification:

FC:

• MCU: STM32F405;
• IMU (gyroscope): ICM42688-P (SPI);
• DJI Air Unit connector: direct connection;
• Blackbox memory: 16 MB integrated;
• Barometer: supported;
• Motor outputs: M1–M6;
• USB connector: Type-C;
• OSD: Betaflight OSD with AT7456E chip;
• BEC: two independent – 5 V / 3 A and 12 V / 2.5 A;
• Firmware Target: GEPRCF405;
• Dimensions: 37.15 x 37.15 mm;
• Mounting: 30.5 x 30.5 mm; Ø4 mm holes, using silicone vibration dampers – Ø3 mm;
• Supply voltage: 3–6S LiPo;
• UARTs: 6;
• Power filter: integrated LC filter;
• Weight: 7.3 g.

ESC:

• Supply voltage: 3–8S LiPo;
• Current measurement: supported;
• Continuous current: 65 A;
• Maximum short-term current: 70 A (5 sec.);
• Supported protocols: DShot150 / DShot300 / DShot600;
• Dimensions: 42 × 45.7 mm;
• Mounting: 30.5 x 30.5 mm; Ø4 mm holes, using silicone vibration dampers – Ø3 mm;
• Weight: 14.9 g;
• Firmware Target: B_X_30.

Package:

1x GEP-F405-HD V3 Flight Controller;
1x TAKER H65_8S_BLS 65A 4IN1 ESC;
1x capacitor;
1x DJI Air Unit adapter cable;
1x flight controller adapter cable;
1x XT60 power cable;
4x M3x30 screws;
4x M3x25 screws;
8x nylon nuts;
8x silicone vibration dampers;
2x SH1.0 4-pin silicone wires;
1x camera connection cable.