GEPRC CineLog35 V2 Analog 6S GPS ELRS 2.4GHz

This is a 3.5-inch FPV drone that combines kinematics, freestyle, recreational flying, and safety - meeting a wide range of user needs for both indoor and outdoor flights.

Installed F722-45A AIO flight controller and new SPEEDX2 2105.5 motors - more power, a more aggressive system and faster response.

Features:

• New look, reinforced carbon panel;
• GEP F722-45A AIO V2 high-performance flight controller is used;
• SPEEDX2 2105.5 engine with HQ DT90 propellers – stable power output and smooth flight feel;
• An XT60E1-M connector is integrated into the frame;

Specification:

• Model: CineLog35 V2 Analog;
• Frame: GEP-CL35 V2;
• Axle distance: 142 mm;
• Gimbal plate: 2.0 mm;
• Top plate: 3.5 mm;
• Bottom plate: 1.5 mm;
• Flight controller: GEP-F722-45A AIO V2;
• Processor (MCU): STM32F722RET6;
• Gyro: ICM 42688-P;
• OSD: Betaflight OSD with AT7456E chip;
• ESC: 8Bit 45A;
• Video Transmitter (VTX): GEPRC RAD 1W (UFL);
• Camera: Caddx Ratel2;
• Antenna: GEPRC Peano 5.8 RHCP (UFL);
• Engine: SPEEDX2 2105.5-2650KV (6S);
• Propellers: HQProp D-T90MM;
• GPS: GEP-M10;
• Receiver: ELRS2.4G;
• Recommended battery: LiPo 6S 1050–1300 mAh;
• Flight time: ~ 8 min 30 sec.

Package:

1× CineLog35 V2 Analog;
2× HQProp D-T90MM (2 pairs);
2× 20 × 250 mm battery straps;
2× Battery silicone mats;
1× Screw set;
1× L-shaped screwdriver (1.5 mm);
1× L-shaped screwdriver (2 mm);
1× L-shaped screwdriver (3 mm);
1× M5 wrench;
1× Plastic tweezers;
1× Antenna mounting tube (pair);
1× Keychain;
1× GoPro camera mounting base;
1× Naked GoPro camera mounting base;
1× Antenna mounting base.

Spare screws included:

2× M2*18 screws;
2× M2*5.5 screws with washers;
1× M2*12 screw;
2× M2 rivets;
4× M2*8 screws;
4× M2*7 screws;
4× M2*6 screws;
2× M2.5*6 screws;
2× M1.6*8 screws;
1× M5 nut;
2× M2*1.9-OD4.9 brass rivets;
2× M2 iron nuts;
2× Camera gimbal shock absorbers;

CLI Dump CineLog35 V2: https://geprc.com/downloads/cinelog35-v2