iFlight BLITZ ATF435 Stack (E55S 4-IN-1 ESC)

Features:

• The latest BLITZ kit for iFlight BNF FPV drones. It uses a super fast AT32F435 processor and a powerful 55A ESC, suitable for 2-6S batteries. The standard 30.5×30.5 mm mounting allows you to easily adapt the board to a new drone frame. The improved electronic circuit with high-quality components ensures lower electrical noise. The DJI HD VTX connector allows for soldering without a soldering iron (Plug-and-Play), and the LED indicators integrated in the controller facilitate diagnostics. There is also a built-in LC filter for effective noise suppression.

Specification:

FC:

• MCU: AT32F435RGT7;
• Gyroscope: ICM42688;
• Barometer: DPS310;
• OSD chip: AT7456E;
• Memory: 32MB (Blackbox flash);
• UART ports: 6;
• Motor outputs: 4x (SH1.0 connector);
• I2C serial: SDA/SLA pins;
• Smartaudio / IRC Tramp VTX protocol support: Yes;
• LED controller: Yes;
• Signal amplifier: Yes;
• Firmware target: IFLIGHT_BLITZ_ATF435;
• Mounting dimensions: 30.5 x 30.5 mm / 4 mm PCB hole diameter;
• Dimensions: 36.5 x 35 mm;
• Weight: 7.8 g;
• BEC: 5V 2.5A / 9V 2A.

ESC:

• Mounting holes: 30.5 x 30.5 mm / Φ4 mm;
• Weight: 14.7 g;
• Supported battery: 2-6S lipo;
• MCU: BB21;
• Continuous current: 55 Amps;
• Maximum current: 65 Amps;
• Current sensor: Yes;
• BEC: None;
• Current setting: 200;
• Supported protocols: DShot DShot150/300/600/MultiShot/OneShot, etc.;
• Target software: QH-25 16.7 (BlheliS) / Bluejay QH-50 (Bluejay) / QH-25 – Bluejay, 0.16, 24kHz.

Connection diagrams:

FC – BF14871_BLITZ-ATF435-FC

ESC – BE14873_BLITZ-E55S-4-IN-1

Package:

1x BLITZ ATF435 flight controller;
1x BLITZ E55S 4-1 2-6S ESC;
1x Wiring kit for ATF435 flight controller;
1x Silicone bushings.