BETAFPV Pavo25 Whoop Quadcopter (Analog VTX)

SMO 4K camera is not included.

Only 6 screws are needed to assemble the drone.

Specification:

• Engines:
Manufacturer: BETAFPV;
Model: 1404 4500KV brushless motors;
Input voltage: 3-4S;
KV: 4500KV.

Measurements

Load testing

• RX: TBS Crossfire Nano RX.

• VTX:
Manufacturer: BETAFPV;
Model: A02 5.8G VTX;
Power: 25/200/500/800mW variable;
Frequency: 5.8GHz 48 channels, with Raceband: 5658~5917MHz;
Antenna: Air Antenna (MMCX Straight).

Measurements

Scheme

• Camera: Caddx Baby Ratel2.

• FC/ESC:
Manufacturer:BETAFPV;
Model: F405 2-4S AIO 20A;
MCU: STM32F405RGT6;
Continuous current: 20A;
Six-Axis: BMI270;
Firmware version: Batefight-BETAFPV405-4.2.X;
IMU: MPU6000 gyro/accelerometer (SPI);
Supports: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600;
Receiver: supports Frsky XM/XM+ Receiver/ Futaba Receiver/ Flysky Receiver/ TBS Crossfire Receiver/DSMX Receiver;
Connector: XT30;
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode);
Input voltage: 2-4s;
Weight: ~5.76g.

Measurements

• Propellers:
Model: D63 3-blade propellers;
Material: PC;
Blades: 3.

Measurements

Package:

1x ready-to-fly drone;
4x Gemfan D63 (2CW+2CCW) 3-blade propellers;
1x 180mm battery strap;
2x EVA Foam Tape (black);
2x EVA Foam Tape (red);
4x 3M Double-Sided Tapes;
1x SMO4K camera mount;
1x SMO4K cable;
1x M5*18 screws;
1x M5 non-slip nut;
10x M2*7 screws.

Battery is not included.